Red Ripper Ultralight Super Stone Router

A lightweight direct-drive router that behaves like stone routers twice its cost.  At 2HP this router doesn't slow down when grinding like the regular Red Ripper Ultralight Stone Router!  That said, it's not for polishing either: this is a pure edge shaping machine. Weighing in at only 22 lbs., you can easily pick up this router with one hand! It is built for profiling sinks and edges, and is perfect for pre-fabs.

The built-in hydroplaning base helps the router move smoothly over the surface of the stone without scratching. Works on both natural and engineered stone. While the router is light, it is no lightweight when it comes to the size of bits it can use - almost all standard 7/8 bore with M10-1.5 bolt router bits will fit and be usable, including all common 2, 3, and 4cm bits. We've even seen guys swing larger bits, but that can cause the machine to become unbalanced, requiring a weight in the back to level things back out again!

Advantages:

• Lightweight 22 lbs., easy enough to lift with one hand
• Fits stone router bits using the industry standard 7/8 inch bore with M10-1.5 bolt
• 8,500 RPM at the bit (no load)

Included Items:

• Red Ripper Ultralight base, spindle, and water shield
• Makita GA7040S grinder
• Inline GFCI with 25ft cord and water-tight quick-disconnect
• 10ft Quick-disconnect water hose