Superior Fusion Colored Adhesive

Superior Fusion is a blend of Vinyl Ester and Modified Acrylic adhesive technology. It is perfect for seaming, mitering, laminating and rodding. Use with natural stone, engineered stone, sintered, ultra-compact and other dense material.

Superior Fusion is certified for use with Neolith sintered stone. The Fusion colors are the perfect balance of translucent and opaque coloring for perfect color matching.

It has a smooth no-drip consistency ideal for vertical and horizontal applications. Uses a standard 10:1 dispensing gun, has fast gel / fast cure, polishes easily and has a 1-year shelf life in a controlled climate. It’s also an amazing adhesive for indoor applications.

Directions:

Be sure to TEST each substrate for bonding and appearance prior to the actual application. FOR MAXIMUM PERFORMANCE, ALWAYS STORE TUBES FLAT WHEN NOT IN USE

• All surfaces to be bonded must be clean and dry
• Load cartridge into dispensing gun, remove locking ring and cartridge plug. Prior to installation of the static tube mixer, the cartridge must be purged to ensure flow of both resin (Part A) and hardener (Part B) from the openings of the cartridge
• Install the static mixer onto the cartridge. The static mixer shall be filled by slowly and consistently squeezing the gun with the mixing tip pointed up (vertical) to remove all air. (NOTE: The locking ring that keeps the cartridge plug installed is also used to lock the static mixer onto the end of the cartridge)
• Once the static mixer is filled to the tip, material shall be purged into a cup or onto scrap cardboard (approximately 10g-20g) before applying to the material. (NOTE: When squeezing the trigger to push material through the static mixer, always squeeze at a constant/consistent rate and pressure. Faster and harder is not good as this causes varying back pressures and pulsing of the cartridge barrel which can lead to off-ratio and poor mix conditions)
• Apply adhesive to seam surface with 1-2 beads and set seam within 4-5 minutes
• Each cartridge color should be evaluated on surface materials that call out the specific cartridge colors as primary or alternate colors. Each cartridge color can be evaluated on other color surfaces of similar hues and shades as well
• Avoid bonding polished surfaces
• Remove / Save cap then install mixing tip provided
• After use, clean openings of both ports, replace cap and discard mixing tip
• Repeat this process for each use

Storage: Store indoors at room temperature. Do NOT store above 75°F (24°C). High heat and cold temperatures will adversely affect the shelf life. Avoid storage in direct sunlight and where freeze/thaw conditions may exist.